Gimbal Ring
 

Hi Guy's I am a new member and I have been reading through Forums looking for a clean thread for my issue, anyway I want to pull the gimbal rinng out and have it rebuilt along with the pin I already pulled the engine and pulled the outdrive because I wanted to clean underneath and clean up the motor. what do I do next?
Thanks for any help.

Sorry for beating up an old issue

Joe

Reply:

Call JR Marine they did one for my boat and it saved me a bundle. In the alternative you could buy a used one but JR does a great job on it damn near new.

You can get everything from them www.jrmarine.com

Take Care

KAP

Yeah thanks for the reply I will probably go that route I am kind of stuck with my next how to fisical next move on the nuts and bolts part of it ,the book is a little sketchy I just need to research and read more I guess.

Hey Joe. I live in Holland prob. not too far from you. If you run into too much trouble, let me know and maybe we can take a look at it sometime.

That is very kind of you, I may take you up on that I will be messing with it to day next hurdle is getting the ring off. small wold 6168362439 if you want to call me

Thanks Joe

Well have everything apart now that I would see more wear and tear then do I had 2-3" of play back and forth the main thing is the tiller arm the pin mics out 3 thousands of in inch of wear at the edges not bad,bottom bushing bad easy fix there, cant figure out why so much play??