Offshoreonly.com - Need some Torque Specs for TRS

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- Drives and Lower Units (https://www.offshoreonly.com/forums/drives-lower-units-217/)

- - Need some Torque Specs for TRS (https://www.offshoreonly.com/forums/drives-lower-units/233451-need-some-torque-specs-trs.html)

Need some Torque Specs for TRS

Hey guys I came up to work on my boat in Maine and forgot my manual for my drives. I need the torque specs for the fallowing

I have to remove the input shaft so I need the specs for the fallowing:

1) The cover bolts at the top of the drive and back cover.

2) The large nut on the back of the input shaft

3) The Tilt Pins for the bell housing

4) Drive to bellhousing bolt.

I think that I have a manual available to me up hear but won't know tell later today so I figured that this could be my back up.

Thanks
Jon

Top and rear cover - 20 ft. lbs.

U-joint shaft nut - 200 ft. lbs.

Hinge pin - 60 ft. lbs.

Drive to bell housing - 80 ft. lbs

Thank you very much.