Offshoreonly.com

Offshoreonly.com (https://www.offshoreonly.com/forums/)
-   Drives and Lower Units (https://www.offshoreonly.com/forums/drives-lower-units-217/)
-   -   Bravo 1, 6th O-ring? (https://www.offshoreonly.com/forums/drives-lower-units/243233-bravo-1-6th-o-ring.html)

bert4332 11-28-2010 08:28 PM
Bravo 1, 6th O-ring?
 
I purchased a O-ring replacement kit and replaced the three on the shaft, the square one, and the one surrounding the shift linkage. The pack came with a 6th, round, but I can't see where it goes. I looked in the Service Manual #11, and I can't find it there. Any suggestions?

thanx

lakematdude 11-29-2010 01:49 AM
Originally Posted by bert4332 (Post 3262672)
I purchased a O-ring replacement kit and replaced the three on the shaft, the square one, and the one surrounding the shift linkage. The pack came with a 6th, round, but I can't see where it goes. I looked in the Service Manual #11, and I can't find it there. Any suggestions?

thanx
It's #5 in the link below, It goes to the drive oil plunger plug valve assembly #16 on the bell housing, You have to glue it on the bell housing to get it to stay in place for drive reassembly, Sometimes It's kind of difficult to remove it and to reinstall it back on.

http://www.mercruiserparts.com/Show_...c=Bell+Housing

Good luck.:drink:


All times are GMT -5. The time now is 07:31 AM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.