TRS BW tranny to inner transom mount alignment
 

So I have an alignment issue and I think I am missing a washer or shim. Does it go from; Inner transom mount UP.

1. Nut
2. Inner transom mount
3. Washer/shim with rubber coating???
4. Transmission mount from the tailstock
5. Washer
6. Spring
7. Bolt
Does anyone know where I can look at a microfiche for this?
As always thanks!

No that's not right Jason. Steel washer, fiber washer and spring go between the mounts. Watch you email. I'm sending you the page out of the manual.

This diagram doesn't show the fiber washer under the top steel washer like the manual and this diagram also shows a washer under the nut at the bottom where as the manual doesn't. However neither of these differences should have anything to do with alignment.
http://www.perfprotech.com/store/ass....aspx#assembly

Jim, Thanks for your help once again.
I do not know if everything was there before I started this project. I always had a problem installing my drives.