Drives for Magic Cat 34
#1
Registered
Thread Starter
Join Date: Sep 2012
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Drives for Magic Cat 34
The boat is Magic Scepter 34 and i have it now here in Finland. So could someone give a good advice what drives i should use?
Engines are 588cid + blowers 1000hp each and drives are Teague XR's (1.35) + 34" Maximus. It now runs 105-107mph with this setup.
Im afraid im gonna blow these drives sooner or later so ...
What do you think about this? I have already a deal for those old Teagues so I need your advice!
Engines are 588cid + blowers 1000hp each and drives are Teague XR's (1.35) + 34" Maximus. It now runs 105-107mph with this setup.
Im afraid im gonna blow these drives sooner or later so ...
What do you think about this? I have already a deal for those old Teagues so I need your advice!
#4
Registered
You can use an extension box and locate the transmissions in the boxes. That's what we did on mine as there was no room in the boat for the tranny.
#6
Registered
iTrader: (5)
Arneson bravo conversion (trans is in the box)
X-Power (shifts internal, 36k EACH!)
NXT Transom assembly/extension box (which houses transmission) coupled with a #6 drive
Custom extension box (like check300's) coupled with a #6 drive
SCX-4 (not proven but better on cats then V's)
SCX (slow you down but gain strength)
On the SCX and SCX-4 dont forget the IMCO stainless gimbal ring, helmet, resovior, WCM blueprinted lowers, etc.
X-Power (shifts internal, 36k EACH!)
NXT Transom assembly/extension box (which houses transmission) coupled with a #6 drive
Custom extension box (like check300's) coupled with a #6 drive
SCX-4 (not proven but better on cats then V's)
SCX (slow you down but gain strength)
On the SCX and SCX-4 dont forget the IMCO stainless gimbal ring, helmet, resovior, WCM blueprinted lowers, etc.