|
Anchor Pin Play
After installing new transom assemblies everything is fairly snug but there's still a little in/out play due to wear in the rear anchor pin bore where the pin passes through the upper drive housing. What's the typical solution for this? Does someone make a bushing kit? I'm estimating the bore to be about .010 worn. Before i have oversized pins made was wondering if there was another route?
|
|
Thanks, he's still on vacation for 2 more weeks.
|
| All times are GMT -5. The time now is 01:28 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.