Anchor Pin Play
03-27-2016, 12:05 PM
#1
Registered
Thread Starter
Join Date: May 2006
Location: Covington, LA
Posts: 281
Likes: 0
Received 0 Likes
on
0 Posts
Anchor Pin Play
After installing new transom assemblies everything is fairly snug but there's still a little in/out play due to wear in the rear anchor pin bore where the pin passes through the upper drive housing. What's the typical solution for this? Does someone make a bushing kit? I'm estimating the bore to be about .010 worn. Before i have oversized pins made was wondering if there was another route?
