Stelling Boxes
09-10-2018 | 01:06 PM
#1
Thread Starter
Registered
Joined: Apr 2006
Posts: 457
Likes: 0
From: Pasadena MD
Stelling Boxes
Hey guys, I am looking for any information on the servicing of The Stelling Bravo extension boxes. I have a diagram of the service points but before I take off the access plates I was wondering, will I find zerk fittings for the carrier bearing, aft U joint, drive shaft and forward U joint? I am also looking for a source for Stelling parts. I realize they are long out of business but was hoping maybe they sold the rights to someone who was interested in carrying on the business. Thanks
09-10-2018 | 01:14 PM
#2
Charter Member # 55
Joined: Oct 2000
Posts: 20,241
Likes: 2,490
From: Omaha/LOTO
You will see the grease zerks. You may have to bump the engines over to get the grease gun onto some of them.
I don't know of any sources that for sure have parts. There have been some threads in the past about some people who might have parts.
I don't know of any sources that for sure have parts. There have been some threads in the past about some people who might have parts.
09-10-2018 | 06:25 PM
#4
Thread Starter
Registered
Joined: Apr 2006
Posts: 457
Likes: 0
From: Pasadena MD
Thanks guys. This is my first boat with Boxes. It a 2003 Fomula 353 with 525s. It was ordered from the factory with that setup. Just want to keep it lubed as I don't want to have to go looking for parts.
09-10-2018 | 07:11 PM
#6
T-Mone
Joined: Sep 2002
Posts: 490
Likes: 2
From: Brookfield CT.
I was also looking for parts at one time. After not being able to find gasket kits I took it upon myself to go through the process to make them myself. Took a few try’s to figure out what durometer rubber for gaskets and o rings worked best. I have complete kits if anyone is interested.
Thanks
Anthony
Thanks
Anthony
09-10-2018 | 07:39 PM
#8
VIP Member
Joined: Nov 2002
Posts: 4,176
Likes: 333
From: ankeny,ia.
if you’re currently in the middle hole, you’ll have to drop the the box down to the top hole or raise the engine an inch to make the straight shaft work
09-10-2018 | 09:05 PM
#10
Thread Starter
Registered
Joined: Apr 2006
Posts: 457
Likes: 0
From: Pasadena MD
Stellings gasket kits
I was also looking for parts at one time. After not being able to find gasket kits I took it upon myself to go through the process to make them myself. Took a few try’s to figure out what durometer rubber for gaskets and o rings worked best. I have complete kits if anyone is interested.
Thanks
Anthony
Thanks
Anthony
