I have seal kits. less the teflon rings for the output shaft. 360-739-7159

Hi Tartilla,

I to am in need of the Merc manual. My latest issue is my boat is slow to go into forward, goes into reverse right way. Also slipped a little if I push too hard on the throttle out of the hole.
could you please send to
[email protected] ?

Thank you.

Hate to bring back an old thread but I’m also looking for info on how to adjust the reverse band on my merctrans wondering if someone can post a picture of where to adjust it or send me a copy of the manual. Thanks

Can't remember if it did when I re-sealed mine but if it's the same as the Ford FMX which it is a copy of it should. The FMX has one and its very obvious, huge bolt through the case on the driver side?. The low/reverse band sees a lot of strain, that's why its so big.

-BL

Please bring back and use these older threads that have tech in them.

I forget the Merc SeMerce Manual Volume. Scribd has them online in pdf.

They are rather large files, and don't email at all.

Anyone have info on tailshaft parts? Sorry to beat the horse on this thread.

I have several Merc 2 trans from my old scarab that I have converted to vp dou props, they were behind Sbc, they would need rebuilds but if you want a spare trans let me know, 200.00 plus shipping, or if you want to convert to bw trans with trs tails I have several of them, also would need rebuilds but if but at least parts available for the borg warners, anyways let me know thanks Andy

Honestly, I just need the aluminum cap that bolts on to the end of tail shaft.

Ok I see what you need, I got your pm, I am not sure why I can’t reply to pm, I will check out how to ship and how much, they are heavy little devils, also my friend on this page Tahiti 25 may have seal kits if you need

Hey I got your pm with number, I feel bad that the shipping is probably more than the trans(I will get shipping amount) I googled where you are and it’s winter where you are, are you in a rush, maybe try the wanted section on this website, if your not in a rush give that a try, if that doesn’t work for you after a while, I will separate the aluminum piece you need.