|
ASD6 Question
The ASD6 project is getting close. We need to shorten the trim ram on the Arneson drive, due to molded swim platform. Does anybody know if the ram end is threaded/pressed/or just inserted with set screws? I hate just going at something without having at least an idea of how its assembled
It was a big block bravo boat now has twin turbo V6 audi/vw 500hp Also is there a magic formula for center of mass for a surface drive, we are about 83.5" from the transom on a 23' boat Thanks, Jason https://cimg3.ibsrv.net/gimg/www.off...8935a50f9e.jpg |
My set up is a asd 7 so my drives are different but mine are held on by set screws .
|
I have copies of the original arneson assembly drawings, I will see if I can find them |
Thank you for the response, Rik emailed me back. The rod is threaded with a roll pin through it, unless its been changed since leaving the factory 30 years ago!. The original drawings would be fantastic!
Thanks Jason |
https://cimg2.ibsrv.net/gimg/www.off...b1fd8e4f8.jpeg Well I have drawings of everything, except an exploded view of the trim cylinders ha! this is the closest I have |
lol, thanks it all helps. No idea how many times its been apart prior to now, and if was reassembled correctly!
Thanks again Jason |
Not to derail this thread, but I thought Rik was MIA?? Did I miss a thread?
Originally Posted by resurrected
(Post 4712857)
Thank you for the response, Rik emailed me back. The rod is threaded with a roll pin through it, unless its been changed since leaving the factory 30 years ago!. The original drawings would be fantastic!
Thanks Jason |
Don't know about MIA, but he was prompt to respond with helpful information
|
| All times are GMT -5. The time now is 08:35 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.