SMartcraft with 525EFI
05-11-2014 | 03:49 AM
#11
Registered
Joined: Jun 2010
Posts: 1,395
Likes: 930
From: LBC, OH
Looking at that service manual description, I'm betting the wires are buried in the harness somewhere.
On a side note, not sure if anyone has ever tested this with Smartcraft, but there is a stand alone CAN output fuel sender available now. It plugs into the data network and sends a fuel level via J1939 to nodes on the network.
http://www.capnavi.com/en/shop/showproduct/12/
I found those units available on another site for about $100
On a side note, not sure if anyone has ever tested this with Smartcraft, but there is a stand alone CAN output fuel sender available now. It plugs into the data network and sends a fuel level via J1939 to nodes on the network.
http://www.capnavi.com/en/shop/showproduct/12/
I found those units available on another site for about $100
05-11-2014 | 04:29 AM
#13
Thread Starter
Registered
Joined: Aug 2007
Posts: 12
Likes: 0
Looking at that service manual description, I'm betting the wires are buried in the harness somewhere.
On a side note, not sure if anyone has ever tested this with Smartcraft, but there is a stand alone CAN output fuel sender available now. It plugs into the data network and sends a fuel level via J1939 to nodes on the network.
http://www.capnavi.com/en/shop/showproduct/12/
I found those units available on another site for about $100
On a side note, not sure if anyone has ever tested this with Smartcraft, but there is a stand alone CAN output fuel sender available now. It plugs into the data network and sends a fuel level via J1939 to nodes on the network.
http://www.capnavi.com/en/shop/showproduct/12/
I found those units available on another site for about $100
But can anyone tell me if it works?
