Anyone know this boat?
#3
Registered
Joined: Sep 2008
Posts: 282
Likes: 0
From: Buffalo, NY
I have a question about this boat or other 33 Daytona's 1999? I have a 33' Daytona 1999 and my Hull has very different steps on it. The boat pictured has a single small step. My boat has two steps and is ventaliated as well. Does anyone have any explanation on this or currently ownes a 33 same year with either step? Very curious.
#4
the last owner was a Mike Thornton from Kentucky.... he repowered the boat with 598 bbc with new blowershop 14's and chillers.
everything on the motors was new...... I built the motors and rigged the boat for him.
1021 hp @6 lbs of boost
Stormbauer
they only did that hull one year the 2000 went back to the two stepped bottom your boat must have been a late 98 boat
Hpm
everything on the motors was new...... I built the motors and rigged the boat for him.
1021 hp @6 lbs of boost
Stormbauer
they only did that hull one year the 2000 went back to the two stepped bottom your boat must have been a late 98 boat
Hpm
#9
I had the boat to 136mph and let out of it...... no windshield or wind flaps makes it hard to see. the boat has so much acceleration that you can rack the throttle and be running 120+ like nothing from 60- 70 mph .
HPM
I am currently building a set of whippled 598's that should make 1200+ hp..... they are going in a 36 nortech.
HPM
I am currently building a set of whippled 598's that should make 1200+ hp..... they are going in a 36 nortech.
#10
As others have stated, the boat is super clean with brand new motors...no expense was spared. Will make someone a great boat, I can't believe how cheap it's listed because I know what the motors alone cost to build...mine were built at the exact same time by the same person utilizing most of the same componets.
Thread
Thread Starter
Forum
Replies
Last Post
kswest
General Boating Discussion
44
04-16-2006 11:25 AM
CAP071
General Boating Discussion
13
03-28-2004 07:04 PM
BK
General Boating Discussion
0
03-11-2004 10:12 AM
Hauling Trash
General Boating Discussion
7
06-11-2002 08:06 PM




