Planning some repairs/upgrades
03-15-2013, 08:38 PM
#52
Been a while since I updated this, Got a little case of the "while I'm at its". I pulled a ton of wiring out of the boat that was attatched to nothing, Secured a lot of loose panels, moved some gauges to make room for more important ones.
Got the stringer dry fit, just need to get a heater in there so I can glass it in. Heat apparently was too expensive in the warehouse.
Every time I work on this boat I get deeper into the "love/hate" It's a labor of love on a boat that I hate how it's been put together. The interior shop did a near perfect job of making all the pieces and fitting it all in. Fit and finish is great, materials all suck! Nothing secured properly etc. God it drives me nuts!! It really sucks, It looks beautiful until you start looking a little deeper, I'm sure it wasn't cheap!
Got the stringer dry fit, just need to get a heater in there so I can glass it in. Heat apparently was too expensive in the warehouse.
Every time I work on this boat I get deeper into the "love/hate" It's a labor of love on a boat that I hate how it's been put together. The interior shop did a near perfect job of making all the pieces and fitting it all in. Fit and finish is great, materials all suck! Nothing secured properly etc. God it drives me nuts!! It really sucks, It looks beautiful until you start looking a little deeper, I'm sure it wasn't cheap!
03-17-2013, 07:18 PM
#53
somebody got some crescent drives
some huber 1330 trannies to.
