|
Re: connecting the 242 to shore power
Originally Posted by Jim Young
I have a 1988 242 and have rebuilt the motor in it. I have a wire that I cannot figure out where it goes and wonder if you could look at yours and tell me where it goes. At my main wiring harness at the front of the motor there is one wire that come out by itself. It is tan with a blue stripe and I think it goes to one of the two water temp sending units on the thermostat housing. If you would look and see if you have a similar wire it would be appreciated.
Thanks, Jim I'll take a look this weekend. You might also post this question to the tech Q&A forum. Is the motor a 7.4L or a 454 magnum? Chuck |
Re: connecting the 242 to shore power
It is a 454 Mag. thanks for your help...
|
Re: connecting the 242 to shore power
1 Attachment(s)
Jim,
I forgot to take the picture you requested over the weekend. Sorry about that. I do however have an older picture. Perhaps you can look at this picture and tell me exactly where you need close up shots. Chuck |
Re: connecting the 242 to shore power
3 Attachment(s)
Jim,
Here are some pictures. I didn't see a tan wire with blue strip at the main harness plug, but rather running along by the intake manifold. I didn't see where it goes as the wiring harness covers it. Perhaps a workshop manual could provide a wiring diagram. Chuck |
| All times are GMT -5. The time now is 07:40 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.