New 382 Dash
#1
Registered
Thread Starter
Join Date: Nov 2005
Posts: 205
Likes: 0
Received 0 Likes
on
0 Posts
New 382 Dash
Check out my new dash.
And, many thanks to everyone here for the ideas and help, and the dash panel Red Dog.
Notice the optimistic new GPS Speedo. I'm ready for some engine upgrades now.
I have to buy a couple of screws to finish the speedo recall install.
I also have to figure out how to mount the GPS antenna. Maybe where the Garmin antenna is now. May have to pull a motor to get to it.
Have a before pic, and a couple of after pics.
And, many thanks to everyone here for the ideas and help, and the dash panel Red Dog.
Notice the optimistic new GPS Speedo. I'm ready for some engine upgrades now.
I have to buy a couple of screws to finish the speedo recall install.
I also have to figure out how to mount the GPS antenna. Maybe where the Garmin antenna is now. May have to pull a motor to get to it.
Have a before pic, and a couple of after pics.
#2
Registered
Thread Starter
Join Date: Nov 2005
Posts: 205
Likes: 0
Received 0 Likes
on
0 Posts
One more pic.
The bend in the dash required a plate to raise the GPS which makes it set higher than I wanted, but overall, I'm pretty jazzed about the way it turned out.
I didn't have to modify the gauge harness very much at all. The tach's are farther apart, so I had to modify the harness buy one of the tach's. The new speedo needed some wiring too, but it was all straight forward.
The bend in the dash required a plate to raise the GPS which makes it set higher than I wanted, but overall, I'm pretty jazzed about the way it turned out.
I didn't have to modify the gauge harness very much at all. The tach's are farther apart, so I had to modify the harness buy one of the tach's. The new speedo needed some wiring too, but it was all straight forward.
#3
Registered
Thread Starter
Join Date: Nov 2005
Posts: 205
Likes: 0
Received 0 Likes
on
0 Posts
I got incredibly lucky on the paint which is almost an identical match to the panels that are already there. I used Dupli-Color ET0335 T336 Peral White. I would just paint the whole thing white,, but I didn't want to re-paint all the other panels.
Thanks for the tip on the rubber gasket at McMaster Carr. Can't remember who told me about it. They also have all the good water proof connectors too and everything else.
Thanks for the tip on the rubber gasket at McMaster Carr. Can't remember who told me about it. They also have all the good water proof connectors too and everything else.
#8
21 and 42 footers
Platinum Member
anybody know what these buttons are for? I have pre-lubers, and HAD Prochargers, could they be some sort of circuit breaker??? Look at the 2 buttons under the ignition switches.
#9
Registered
Thread Starter
Join Date: Nov 2005
Posts: 205
Likes: 0
Received 0 Likes
on
0 Posts
#10
Registered
Thread Starter
Join Date: Nov 2005
Posts: 205
Likes: 0
Received 0 Likes
on
0 Posts