Alright guys,
I recieved the filler cushion from Formula (post delivery), therefore I never recieved any instructions on how to set the dang thing up. I've tried all the poles that came with the table and then tried the table with the shortest pole, but nothing works. Am I missing a component/pole, etc or am I just not bright enough to figure it out? Any advice you can give will be much appreciated.
Thanks!
Corey

I have those times also.

Someone will pipe up pretty soon and direct your efforts

the 3 filler boards are above the fridge (should be). They slide in from the cabinet/head end onto a small 'shelf/slot' under the settee cushions bottom edge. 3 cushions.

I'm going to have a one piece cushion done with fabric and 3 velcro strips on the bottom and fabricate a stealth stop for the last board out.

The existing system just doesn't...ummm...perform

Well I'm feeling a bit better I was begining to think I was losing it. I don't have the 3 filler boards that you mentioned.

Does anyone know where I can buy these? Or have 3 they can sell me?

I think I have them in stock,I'll take a look later today.

I have them,actually there are 4 of them,( can you believe Rippem made a mistake?) part #26630TAG,retail $188.30 each,for a whopping $753.20. These were in a trade in boat that had lost the cushions,so I saved the panels.Don't need them,will make you an Alabama friendly deal

Cheers to Magic.......another example of stepping up and helping out a Formula owner.

Sounds Good Magic! I'll call you in the morning!

uhh...no

No mistake made? or No, you can't believe you made one?