trip2 did you get the panel from the same guy as t500? If not who can you recommend? Please post pics....

Thanks,
JB

He's dealing with the same guy.....and it's 5 panels!!!!
....and I decided to replace the wheel like the newer ones too.

jb same guy Steve at innotech and I recommend him super nice guy to work with, and the 419 needed 7 peices

t500 you did go from a raised panel to an all flat panel for the center dash right? and the only needed change was the locaton of the latch on the back?

Mine was already a flat panel. I tried to take measurements for Steve (Innotech) to install the bar/latch piece on the back of the panel but found a better way. When you get the panel back from Innotech, install it on the hinges so it's mounted in the dash without ANY gauges. Apply epoxy/glue the the flat portion of the latch, clip it in where it will meet the dash, then close the panel while holding the catch/latch piece through the tach holes. I only needed to hold it in place a minute or so til the epoxy setup a little. Once it's dried it's in the proper place and you can remove the panel to start installing gauges.