Oil Pan Drain Hoses
 

Do any of you have the hoses attached to the bottom of your oil pan to drain oil? If so, what size are they and where did you get them? I was going to have them installed last time my engines were out but they were too thick to pull out by bilge drain holes. My engines are out (again) and I would like to install these hoses.

CP sells them. Not sure if they are small enough to come out through the drain plug tho.

Overtons,ya can do a search on goggle it will show a few other.thieve been running around 14-20. I put longer hoses on mine

Picks post 15
http://www.offshoreonly.com/forums/h...-how-easy.html

So they aren't meant to be pulled thru the bilge drain plugs, they're meant to be connected to a drain pump?

They connect to the drain plug by chain so when you take the plug out you can pull them through the hole.

Sleek, this might be what your looking for http://www.cpperformance.com/detail.aspx?ID=902

Check into the hoses that Merc uses on the 525's, actually I think they install them on every engine package these days, they will pull thru the standard size hull drain plugs. Bam Marine site should allow you to find the part numbers.

Thanks for the help guys, that is exactly what I'm looking for.

either or. I just suck mine out.quick connect fitting make it nice ,not a drip,mines 5 gallons at a time

rob:drink:

Hey Rob, What quick connect fittings do you use? Do you have a picture or part number?

I have the hoses to the oil pan, y-block and quick change pump installed in my boat, but have never been able to find a GOOD quick connect for the output side of the pump.

Thanks,
Dave