Only going up WHY?
#1
Gold Member
Gold Member
Thread Starter
Join Date: Jan 2011
Location: Syracuse, NY
Posts: 1,097
Likes: 0
Received 0 Likes
on
0 Posts
Only going up WHY?
OMC stringer outdrive only will go up, but won't go down under power. Isn't it the same trim motor? And the motor is a chevy 350 (omc 260) it won't circulate water? Is there a way to bypass the water pick ups and check only the water pump? What if I pull the thermostat out?
#2
Gold Member
Gold Member
Thread Starter
Join Date: Jan 2011
Location: Syracuse, NY
Posts: 1,097
Likes: 0
Received 0 Likes
on
0 Posts
Forgot to mention, when I push the tilt switch down, it kills the motor if its running, but the outdrive comes up as normal when the tilt switch is pushed up, motor stays running fine, no drop in rpm
#4
Gold Member
Gold Member
Thread Starter
Join Date: Jan 2011
Location: Syracuse, NY
Posts: 1,097
Likes: 0
Received 0 Likes
on
0 Posts
I didn't check. I'll do that next. I don't believe it does though... What would a voltage drop mean? What would a lack of a voltage drop mean?
#5
Registered
My brother has had a few of these stringer drives in the past...I'll ask him. Seems that I remember him telling me about several different solonoids and that they were just like the ones that Ford used to use as remote starter solonoids...cheap and available everywhere. Check to see if ther is an up solonoid as well as a down solonoid...if there is that could be your problem. I will ask and get back to you here.
#7
Registered
OK...spoke with my brother...says that as he recalls there are 4 solonoids. I don't know where they are mounted but could be anywhere. The way to verify if that is your problem is to locate each and put a jumper wire accross the solonid lugs to see if the pump runs down when you jump it...if it does then you know. You can buy those solonoids at BOW or West or even Auto Zone...they are the same. Shoudn't be more than $10~$12 or so...he said always carry spares because when they fail you are stuck.
Hope this helps.
Hope this helps.
#8
Gold Member
Gold Member
Thread Starter
Join Date: Jan 2011
Location: Syracuse, NY
Posts: 1,097
Likes: 0
Received 0 Likes
on
0 Posts
Thanks sprink, I'll check them out and it's probably that. Any idea why water would come out of the thermostat housing but not circulate through the rest of the motor?
#9
Registered
#10
Gold Member
Gold Member
Thread Starter
Join Date: Jan 2011
Location: Syracuse, NY
Posts: 1,097
Likes: 0
Received 0 Likes
on
0 Posts
I tested hoses?thermostat etc and the diagnoses is that the impeller isn't pushing in sufficient water. So... I have a new impeller kit, I need help getting this stringer outdrive apart. Anyone that has dealt with this drive?