Formula Guru's
#1
Registered
Thread Starter
Formula Guru's
Reposting here since I didn't get any answers in General Q & A, does anyone know what these cans are that are welded to my tails on 1990 357 SR1 420/TRS? First time I have seen them so I am curious.
#3
Registered
Thread Starter
#4
Registered
My guess would be some type of muffler, since the flapper is usually in the tail piece. What else would you do to an exhaust?
The following 3 users liked this post by resurrected:
#6
Registered
I always install the flux capacitor on the shifter. easy to get to.
The following users liked this post:
resurrected (06-22-2020)
#7
Registered
Thread Starter
The following users liked this post:
resurrected (06-23-2020)
#8
Registered
Thread Starter
The following users liked this post:
resurrected (06-23-2020)
#9
Registered
Thread Starter
On a side note, I opened up the silent thunder platform as I have all previous birds and this boat much quieter than ones in the past. I am going to have a closer look when I put the tails to put in new gaskets and plates - might end up cutting the off to let her exhale a little better.
The following users liked this post:
Smoke eater (06-22-2020)
#10
Registered
On a side note, I opened up the silent thunder platform as I have all previous birds and this boat much quieter than ones in the past. I am going to have a closer look when I put the tails to put in new gaskets and plates - might end up cutting the off to let her exhale a little better.