Originally Posted by mjc (Post 3684336)

This is what i did. I took the panels off and had my local shop make some just like fountain did. They used my panel so everything bolted right back up. I can't find any pictures right now but they look just the same as factory

Originally Posted by JoCo32 (Post 3684575)

I had a local guy make them and just screwed them to the existing panal. Can't tell it from factory.
http://i564.photobucket.com/albums/s...4-22-12031.jpg

Originally Posted by JoCo32 (Post 3685789)

It's from Fountain, had holes for gauges. Just cut it out for the Garmin and had Steve make the panal to match the dash

Originally Posted by JoCo32 (Post 3684575)

I had a local guy make them and just screwed them to the existing panal. Can't tell it from factory.
http://i564.photobucket.com/albums/s...4-22-12031.jpg

Originally Posted by msobczyk (Post 3684356)

What did that run you? And where is this shop located?

Originally Posted by mjc (Post 3686925)

I had mine done in Lake Havasu and I have less than $200 in them if i remember. I can get pictures this weekend as I get to go boating.

Originally Posted by US1 Fountain (Post 3686174)

You have a side shot of the switch panel?

I'm thinking of removing the VHF, but will be left with the large hole.