drive monitor help for xr bravo
#1
Platinum Member
Platinum Member
Thread Starter
Join Date: Jan 2006
Location: Brookyn NY
Posts: 171
Likes: 0
Received 0 Likes
on
0 Posts
drive monitor help for xr bravo
I just installed the 6 oz bottles on bravo xrs
2/3 full they expanded over the top while running warm
and settled to near bottom when cooled with no visablility after cooling . Are they the wrong size for my drives?
thanks for input
2/3 full they expanded over the top while running warm
and settled to near bottom when cooled with no visablility after cooling . Are they the wrong size for my drives?
thanks for input
#2
Registered
iTrader: (1)
Join Date: Oct 2005
Location: Orangeville, ONT. CAN
Posts: 589
Likes: 0
Received 0 Likes
on
0 Posts
Just a guess but it might be air in the line.
I had the same thing happen to my closed cooled bottles on one motor and when I looked the resevoir was about 3/4 full and when cold only a little sits in the bottle. Ran hot, filled up and when we looked at it actually saw all the air bubbles come up the line and the resovoir went back down the problem was then fixed....................
Just my 2 cents.......
I had the same thing happen to my closed cooled bottles on one motor and when I looked the resevoir was about 3/4 full and when cold only a little sits in the bottle. Ran hot, filled up and when we looked at it actually saw all the air bubbles come up the line and the resovoir went back down the problem was then fixed....................
Just my 2 cents.......
Thread
Thread Starter
Forum
Replies
Last Post
1BIGJIM
Drives and Lower Units
3
06-10-2008 12:46 PM
panteraracin
General Q & A
3
02-07-2002 10:36 PM