switch dash from trips to twins
#3
Crazy Energy
Joined: Aug 2007
Posts: 4,334
Likes: 1
From: Oklahoma God's country no one else wants it.
I would leave the wiring on the third incase someone ever went back to tripps. I just redid my dash, once you get started it isn't that bad, VV
Color chart:
(BIA) Color Where Used
Black All Grounds
Black/Yellow Ignition kill circuit
Brown Alternator charge light
Pumps (bilge, live-well, etc.)
Reference Electrode - MerCathode
Brown/Orange Power feed to Auto-bilge switches
Orange Accessory common feed
Distribution Panel to Accessory switch
Anode Electrode - MerCathode
Orange Alternator Output to Ammeter
Lt. Blue/White Trim -"Up" Switch
Gray Tachometer Signal
Dark Gray Navigation Lights
Green/White Trim -"Down" Switch
Tan Water Temp. Sender to Gauge
Lt. Blue Oil Pressure Sender (10 Gauge)
Pink Fuel Gauge Sender to Gauge
Brown/White Trim Sender to Trim Gauge
Purple/White Trim -"Trailer" Switch
Red Unprotected Wires from Battery
Red/Purple Protected (Fused) Wires from Battery
Protected (+12V) to Trim Panel
Purple/Yellow Ballast Bypass
Purple (+12V) Ignition power feed from Switch
Instrument power feed
Yellow Bilge blowers
Alternator field to reg. field terminal
Starter Solenoid to Starter Motor
(MCM 470 and some Ford products)
Yellow/Red Starter Switch to Starter Solenoid
to Neutral Start switch
Tan/blue Warning system sense wire
(Audio warning)
Yellow/Black Neutral Safety switch
(transmission mounted)
White/Green Ignition module to Distributor
(Mercury Thunderbolt ignition)
White/Red Ignition module to Distributor
(Mercury Thunderbolt Ignition)
Dark Green Bonding Wires (earth ground)
Dark blue Cabin, courtesy, and instrument lights
Before

After
Color chart:
(BIA) Color Where Used
Black All Grounds
Black/Yellow Ignition kill circuit
Brown Alternator charge light
Pumps (bilge, live-well, etc.)
Reference Electrode - MerCathode
Brown/Orange Power feed to Auto-bilge switches
Orange Accessory common feed
Distribution Panel to Accessory switch
Anode Electrode - MerCathode
Orange Alternator Output to Ammeter
Lt. Blue/White Trim -"Up" Switch
Gray Tachometer Signal
Dark Gray Navigation Lights
Green/White Trim -"Down" Switch
Tan Water Temp. Sender to Gauge
Lt. Blue Oil Pressure Sender (10 Gauge)
Pink Fuel Gauge Sender to Gauge
Brown/White Trim Sender to Trim Gauge
Purple/White Trim -"Trailer" Switch
Red Unprotected Wires from Battery
Red/Purple Protected (Fused) Wires from Battery
Protected (+12V) to Trim Panel
Purple/Yellow Ballast Bypass
Purple (+12V) Ignition power feed from Switch
Instrument power feed
Yellow Bilge blowers
Alternator field to reg. field terminal
Starter Solenoid to Starter Motor
(MCM 470 and some Ford products)
Yellow/Red Starter Switch to Starter Solenoid
to Neutral Start switch
Tan/blue Warning system sense wire
(Audio warning)
Yellow/Black Neutral Safety switch
(transmission mounted)
White/Green Ignition module to Distributor
(Mercury Thunderbolt ignition)
White/Red Ignition module to Distributor
(Mercury Thunderbolt Ignition)
Dark Green Bonding Wires (earth ground)
Dark blue Cabin, courtesy, and instrument lights
Before

After
#7
Crazy Energy
Joined: Aug 2007
Posts: 4,334
Likes: 1
From: Oklahoma God's country no one else wants it.
Pull the panel back, turn the key on and use a test light on the purple wire Ignition there is one purple wire on each gauge. Black is ground , dark blue is hot to light, the other color depending on the gauge goes to sensor.
Last edited by Velocity Vector; 03-24-2008 at 11:34 PM.


