Dirtydeeds715

I have a 32 fountain with twin Hp500 carb motors, after i have been running the port motor starts losing about 500 rpms, i changed the plugs,filters wires, does any body have any ideas where i should look next? thanks

88bullet

iTrader: (1)

compression and cyl leakage

Dirtydeeds715

the compresion was good, i should have added it only seems to happen above 3000 rpms.

Wildman_grafix

Did you check the timing?

88bullet

iTrader: (1)

pick up in tank

Dirtydeeds715

i did check the timing when i did the plugs and stuff, i dont think its the pickup because the motor will turn 5200 rms the first couple times i run it up then after that is when it drops off.

88bullet

iTrader: (1)

outdrive starting to tighten up after it gets warm??

KWright

When it warms up check your coil make sure its not shorting to ground will only do this when warm also check sensor inside dist for corrosion.

tman

iTrader: (1)

+1 I had a bad coil wire that would do the same thing.

JoCo32

Mine was simular, check the ground for the ignition pickups. The nut was loose on the port motor and would only turn 4500 wot