I experimented with this with under the cooler I couldnt get it to work. Then mounted under back seat. Come to find out if your going to do the cooler your going to probably need a 0 Gauge ground wire think I was using a 4 or 6 and it wouldnt work. Needless to say in the middle of the project I wasnt going to take the time and money to go find some wire so it went under the seat.

You need like 2 ohms going to that ground or work.

thanks for the info guys...

is the rub rail around the transom thrue bolted?
I need to replace that rear section,,anybody know were I can buy a section??

Thanks

anybody have a picture they can post of a sunpad from a 32 with the Fountain logo and the 32 in the center of it?

Thanks again

no

just screwed i think

http://www.marinewholesaleinc.com/ta.../builders.html

The other drain is the cooler drain for sure.

no its not,,i purred r/v antifreeze in the cooler and did not drain out of there..

The large thru hull is the sink drain. the other is for the bilge pump inside the cabin step.
The cooler just drains into the hull. Pizz poor design!

thanks,,kind of what I thought..I think Iam going to connect the cooler to the sink drain..

I don't think the cooler will fully drain if you do so. Maybe just enough that a sponge or towel will pick up. To close to call. I thought of doing so too when I 1st bought my boat.