I'm not at all worried about vibration underway, just while idling out. Thank you soooo much for the test. I have been going between downturns, or getting 4 4inch, 18 inch long stainless pipes that I could connect to the exhaust outside the transom that just cleared the swim platform. My only concern with that is that it would be a lot of sharp metal out back when you tried to crawl in the boa from the water. I think the rubber downturns might be the way to go.

Ordered...thanks for the link! I'll let ya'll know how it works.

The elbows work great. Easy and off. I put my 2nd motor in last night.

Lookin goood!!!!

Looking good glen. How is el sol doing on the interior?

All done. I will install everything next week. I took off work.

ok I finally got to take the boat out over the weekend and I am glad to report the tips worked great and you are able to idle around with the exhaust on and not rattle yourself to death,,,

I have dry pipes to the tip. I decided to open up my downturns with a 2" holesaw. My rubrail is out of the water. Water test this weekend.

You going to be on Oneida this weekend? I have some boats coming down from north to tear up the lake this weekend

Yes. I have my brewerton boat works season pass. I will be out there.