Fever dash upgrade - almost finished
 

Here's a photo of where I started - dated and worn black dash, original SW gauges looking tired.

http://i531.photobucket.com/albums/d...sw1x1p5mk.jpeg

I stripped and repainted the dash white, the lettering is all painted on with metallic teal and a few coats of clear, New Autometer gauges and teal bezels. I also rebuild the throttle and shifter with new wear pads and springs and a fresh coat of white paint. Similarly I did the engine hatch switch panel and both power bolster switch plates. I'm hoping when installed it make the boat feel like something from this century.

http://i531.photobucket.com/albums/d...srk1skdnm.jpeg

http://i531.photobucket.com/albums/d...slt8rhckp.jpeg

I'll post up some more photos when I get it installed in the boat along with the new wheel.

Ryan

Very nice job. Looks good. Did you paint the lettering or someone else?

ICU - Thanks!

I painted it. I did a white base, masked everything that wasn't a letter and shot with the teal. It was a colossal pain to get everything lined up properly, and there area few small mistakes that probably I'll only notice - nothing worth a repaint over.

Ryan

Really nice work!!

That's a lot of small masking and impressive.

Looks good. Whats the logo?

Looks great. I can see the glossy reflection in the white panel. What are you going to use for a wheel?

Thanks all.

US1 - It's not a logo per say, it's my signature. I was going to sign the back, but I had all that extra white space that was begging for something.

F350 - I found a white fountain wheel to use for now.

I plan on installing towards the end of April assuming the snow is finally finished.

Ryan

Looks great! Really nice dash sets off a boat!

Looks nice!

I have an extra wheel if your interested. 100.00 and I'll cover the ride or 75.00 + freight. I purchased for my last dash and ended up buying a red one. Never installed.

◦Wheel Kit Part Number: ISWK13CFBK
http://www.livorsi.com/catalog/wheels_isotta.htm