|
https://cimg4.ibsrv.net/gimg/www.off...aee359e408.jpg
Everything is going to fit. https://cimg1.ibsrv.net/gimg/www.off...de4521ef7e.jpg |
Oil pans, drysump tanks, power steering tank, valve covers, and heads will all go to be anodized. When heads get back they will go to RFD to be cnced, seats and guides installed.
|
|
https://cimg4.ibsrv.net/gimg/www.off...c666b15ff2.jpg
Lazer alignment tool, to get crank centerline on forward engine. |
Refresh me again, what horsepower are you expecting out of these?
|
They made 750, before the upgrades. So we will have to wait and see. If I had to guess I would say right around 755.
|
Originally Posted by KWright
(Post 4618465)
They made 750, before the upgrades. So we will have to wait and see. If I had to guess I would say right around 755.
|
We had brodix polish them they are being hard anodized blue, then off to RFD to be cnced. These have the offset runner in them so you have to run a offset in the rocker shafts.
|
Had to check the flow #s, intake is 490, exhaust is 340. They are 24B not 23B. My bad. Should be back mid week from being anodized. I'll post some pics when I get them.
|
https://cimg7.ibsrv.net/gimg/www.off...59d10f9c1d.jpg
Been working on blueprinting bottom this week, should have it finished up next week. |
| All times are GMT -5. The time now is 11:38 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.