Finally got the last of the fittings in to run the sea pump on the dyno. Made 3 easy pulls to 5500. Will readjust valves tomorrow, make a couple adjustments then go for a full pull. Was a little worried with the big heads and exhaust that I might have some trouble down at lower rpm. I moved to a 1.35 year ratio used to run 1.5. But at 3500 rpm making over 90 more ft lbs.

This should work.

When you want to run the big wix filter but it is 1/2 inch too high and hits your tail pipe. No problem have billet Mike make you one 3/4 inch shorter!

Should be the end of this week.

Updates??