Thru hull water pick up
#1
Registered
Thread Starter
Thru hull water pick up
My boat is starving for water. 575 Engine running hot all new pumps, probably due to transom suction hose. Any thoughts pros/cons?
#2
Registered
#3
Registered
What kind of water do you run in, ie brackish, silt? Do you have a sea or sand strainer? Flush motor periodically?
#5
Registered
Thread Starter
My engine builder says absolutely put the key through transom or through haul water pick up on the guy that works on the boat other than the engine says no use the normal pick up through the transom assembly and I’ll drive not sure which way to go
#6
Registered
#7
Registered
Did you add the sea strainers? if so do you still have the screens in the bottom of the offshore pickups? I was told if you add sea strainers you should remove the screen/grill on the bottom of the pickup.
#8
VIP Member
VIP Member
You know your water pressure but whats your water flow? Remember water pressure can be had without hardly any water flowing and this would be a potential for overheat condition.
#9
Registered
What are oil temps like?
#10
Gold Member
Gold Member
Join Date: Dec 2000
Location: Newport,DE
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
It may be a long shot but I had sand granuals jam up the nylon check balls holding them open in the thermostat housing. Part #9. Take your hoses off both sides and make sure they are not hung open,
Last edited by MaxPerf; 06-07-2019 at 08:03 AM.