Has anyone had to remount their cabin electrical panel (holds shore power outlet, breakers, etc)? I see most fountains have the piping trim falling out around the border too. Any suggestions would be appreciated.

You mean just tightening the screws up? I am currently just now putting my cabin back together been in just about every spot you can work on.

Tightening the screws up and fixing the round piping trimming it out. Everyone seems to have the trim falling out problem

If you have taken that piece off you see that the piping is just glued on. it gets sandwiched in between the top and bottom. To be honest once in I never have an issue with it falling out mine is tight. It is a bit of a PITA to put in. This time I am going to wrap mine with some carbon fiber film to match the new seats.

I was going to remove the whole panel this winter and try to re-glue the piping/trim. Then try to tighten all screws. I noticed every used fountain online has this issue. Why don’t more people fix this? It looks horrible.

Pictures?

You made me go and look at the fountains for sell on this site, I seen a couple with the issue you are talking.

Look at the 2004 38’ fountain in the classifieds section.