Muffler mount and gasket

Gasket and ring, The gasket is 3/16 thick and will withstand 500 degrees. it is Silicone Rubber 50 Durometer. Hope it works.

Ray- ST450's?
 

Ray, have you looked into Teague's ST450's? Check them out --I think they are the style you are looking for. I have them on my Fountain. Keep up the good work. I have followed your product since day one. ;)

I have been working on the plumbing and wires. I almost have the transom done. I spruced up the Fresh water flushes. I painted the brackets with Epoxy paint, the stuff you use on appliances. It looks much better. I also attached the pipe with a 1 3/8" x 2 1/2 x 5/16" U bolt instead of the hose clamp. I also ground down the valve body so it sits flat on the bracket. ( I like details)

Old picture:

In process Grinding the valve boss flat.

Paint

a couple more shots, Mufflers back on

Bilge area, It's taking much longer than expected but I only can work 1 or 2 hours a day. Next thing that goes in is the sea strainers.

New Bilge pumps and hose done too.

Exhaust mounting ring.