|
Re: Pics of TMP/Extreme Hustler Project
Originally Posted by HiPerf2000
Mike,
It would be a redline of 10205.............49% of 10,205 = 5000. ;) :p |
Re: Pics of TMP/Extreme Hustler Project
Originally Posted by totalmp
Unfortunately, Redline is around 5600. The boat was way underpropped, as they were gauging propeller and gear ratio from the turbo boat. Even with the 34" propellers at 5600 the boat should be around 128MPH, at probably around 75% throttle. We will be setting the boat up to cruise over 100, as the customer will be doing several poker runs.
|
Re: Pics of TMP/Extreme Hustler Project
It went from 50 to over a hundred in about 3 seconds. The throttles are like playing with two chainsaws...the minute you stop respecting them, you are going to get your arms cutoff!
|
Re: Pics of TMP/Extreme Hustler Project
Anyone know what the appr. weight is of this hull, are the newer 388's lighter or slightly heavier, thanks Jeff
|
Re: Pics of TMP/Extreme Hustler Project
388 is about 8500 lbs..... don't know if that is lighter or heavier than earlier versions, i would assume if anything, lighter?
|
Re: Pics of TMP/Extreme Hustler Project
Dont know if the older, Paul Fiore days, 388's are different than the newer ones, but, I know the Schott brothers(Black Cloud) out of LI had to shave 16 inches off the tail end of the inner pair of lifting strakes to make the boat controllable w/ ASD's.
I guess over 110 it was all over the place. They are the guys to talk to if bottom modding needs to be done. They've had it to 144 w/ their 1400's. I hear the new owner up here in the 1000 isles is knocking on 150 w/ it.. |
Re: Pics of TMP/Extreme Hustler Project
Awsome speeds!
What is the weight of the fully rigged hull?
Originally Posted by Rik
Your suppose to get the girls dresses caught on them!
|
Re: Pics of TMP/Extreme Hustler Project
has anyone tried a ballast tank to calm em down over 100??
|
Re: Pics of TMP/Extreme Hustler Project
i know i wasnt exact goofy! :D
|
Re: Pics of TMP/Extreme Hustler Project
Well, I got my first Arneson lesson today. We were all standing around waiting on Fed-Ex to deliver the new props from Mercury. He finally rolled up about 4pm and we were slinging boxes and bolting them up. I put the small sleeve "big shaft #6" on and it still had a lot of play??? WTF??? Put the big sleeve "small shaft #3 or#5" and I still have slack??? Get out the Micrometer, a #6 Merc has 1.88" shaft, #5 or big shaft #3 has a 1.75" shaft.....but the Arneson 6 has a 1.69" shaft but still has the #6 Merc spline.....it just has no shoulder. Arneson overnighted the correct sleeves from Cali.....supposed to be here by 10AM. Hopefully we will be on the water tomorrow and can do some testing with the bigger wheels.
|
| All times are GMT -5. The time now is 12:06 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.