servicing trs drives
#1
Registered
Thread Starter
servicing trs drives
I'm in the process of servicing my trs drives. Any suggestions on the best tool for aligning the drive shaft as I replace the unit. Thanks
#4
Registered
Re: servicing trs drives
Originally Posted by jhiguy377
thanks insptech, i need all the help i can get keeping this old dog alive.
#5
Registered
Re: servicing trs drives
It's hopless without the alignment tool unless you get real lucky.
insptech is correct, when you get it lined up you'll feel like Michael Jackson during nap time!
As far as keeping that old dog alive, you're better off with the TRS' over all the Bravo guys. When you're ready just pick up a set of Konrads.
insptech is correct, when you get it lined up you'll feel like Michael Jackson during nap time!
As far as keeping that old dog alive, you're better off with the TRS' over all the Bravo guys. When you're ready just pick up a set of Konrads.
Last edited by Lofty; 10-04-2005 at 07:10 PM.
#8
Registered
Thread Starter
Re: servicing trs drives
Thanks for all the input guys; I take it pretty easy these days- had my heyday of blowing up motors trannies, drives etc. I would like to get some info on spare TRS's though. I'm not familiar with all these new drives-Bravo, etc. as its been about 20 years since my last boat. Back then we were willing to lose a bit of horsepower for the sake of durability.
#9
Re: servicing trs drives
Originally Posted by jhiguy377
Thanks for all the input guys; I take it pretty easy these days- had my heyday of blowing up motors trannies, drives etc. I would like to get some info on spare TRS's though. I'm not familiar with all these new drives-Bravo, etc. as its been about 20 years since my last boat. Back then we were willing to lose a bit of horsepower for the sake of durability.
Thread
Thread Starter
Forum
Replies
Last Post
Dean Ferry
General Boating Discussion
4
11-27-2002 08:09 AM