scooter,

[email protected]

I'll look forward to seeing them.

[ 01-30-2002: Message edited by: thisistank ]

Hey, tank i have the women scanning them at work, and saving them on a disk should have them to send tomorrow.

Thanks brother....If you can throw in some of the whole boat I'd like to see it. It sounds killer! ;)

How about Eickert manifolds? Full-length runners, and dry all the way to the tip. Since they are cast aluminum, I don't know how much power they can take, though. I would call Eickert and talk to Brett or Keith.

Oh - they're LOUD, too. Very :D

Tank you will be good to go t will send a few, what kind of baja do you have?

check your e-mail for pics of stainless marine setup.

Stainless Marine Dominator III 's are great and very durable. I ran 1300 hp through them and they made me long custom 5 inch tail pipes for around $2800. And they sounded nasty!

I have had 3 sets of lightning headers two sets are now 4 years old no problems. The older headers had a lot of cracking problems.

Tank,
Even though the Gils have the water inlet at the base of the riser, the water exits the riser at the end. They are a tube within a tube, so water is not being dumped into the exhaust at the base. Sure most of the exhaust brands are this way. Naturally a riser for a silent choice system is going to be shorter than a straight thru hull, so water is introduced closer to the bend with the choice exhaust. Look at my "blower power" pic. Gil risers with silent choice. No reversion problems.
Jerry

http://community.webshots.com/user/us1fountain

this---- I've wasted (2) 572 motors on "cheap" lightning headers. I know what you are saying. Thats why I say, CMI's.