My fabrication shop has unfortuantely closed and I'm looking for someone to modify the ends of my tialpipes. Just need the 4" cone-down section at the end removed and replaced with similar length 4 1/2" section to accommodate 4 1/2 " clamp-on mufflers. This is in the single-walled section outside the transom after the water dump. Anyone know a shop that can do this?

more:

Since it's a CMI product, why not use them?

Call Randy at CMI 920 722 7084

Chris call me. Greg

drpo them off, I have one of those new cold heat sodering guns I am dying to try out

Fred,

Just e-mailed photos to Randy today, waiting for a response. Point he made on the phone was the tailpipes were modified by someone else in the recent past ... they may not want to deal with "someone else's" stuff. Actually, I gave him your name as a customer character reference.

By the way, I recieved the Lifeline vests tonight. I'm very satisfied with them. Also recieved the 4 1/2" GGB's I traded out with Lofty. Thanks for your help!

Greg,

I'll try to stop by if your in the shop tomarrow.

Thanks,

Chris

Nothing special there. Cut off the add on just before the weld, Tig on a new peice. Any body with a Tig welder can do that.
Is the 4 1/2" not longer enough for the mufflers?

What are the 2 drains for?

Red Dog, where did you get the white rubber gasket for the outside of the tailpipe. I need to replace mine but have always used a thicker black rubber?

Need at least 2 1/2 " outside the seals for proper clamping.

The two drains were water dumps from previous rigging (previous owner) of Stellings dry exhaust and 950 h.p. blower motors.