New model skater done!
super sweet
02-01-2006 | 06:08 PM
#15
Thread Starter
Registered
Joined: Mar 2001
Posts: 1,981
Likes: 7
From: Livonia Mi Usa
Re: New model skater done!
I Started With A Ballentine Hobby Model And Then Cut Off The Deck And Made A Plug Of The Skater Deck Then Pulled A Mold Off That Then Made The Part And Glassed It Back On The Hull Tons Of Work But Well Worth It I Have The Deck Mold If Someone Want To Build One The Outbords I Made A Mold Of The Cowls And Made Them Out Of Glass And Had The Decals Made At A Graphics Shop
02-02-2006 | 01:14 AM
#16
Registered
Joined: Mar 2002
Posts: 360
Likes: 0
From: Livonia, Michigan
Re: New model skater done!
Originally Posted by JIMKID Motorsports
I Started With A Ballentine Hobby Model And Then Cut Off The Deck And Made A Plug Of The Skater Deck Then Pulled A Mold Off That Then Made The Part And Glassed It Back On The Hull Tons Of Work But Well Worth It I Have The Deck Mold If Someone Want To Build One The Outbords I Made A Mold Of The Cowls And Made Them Out Of Glass And Had The Decals Made At A Graphics Shop
02-04-2006 | 07:24 AM
#19
Thread Starter
Registered
Joined: Mar 2001
Posts: 1,981
Likes: 7
From: Livonia Mi Usa
Re: New model skater done!
Hay Comance I Did A 72 Inch Apache About 15 Years Ago With Twin 35 Cc Quadra Motors And Had Mercury Outdrives Had A three Channel Radio And Could Trim It From Shore. Ill Try And Post Some Pictures Of It. It Was In Model Boat Magazine they Did A Artickle On It, My New Boat Is Going To Be In Model Boat Mag This Summe. Chromcat I Started With A Ballentines Hobby Hull Then Cut The Deck Off And Made The Skater Deck
Last edited by JIMKID Motorsports; 02-04-2006 at 07:28 AM.
Thread
Thread Starter
Forum
Replies
Last Post
skaterboy
General Boating Discussion
10
04-05-2006 09:08 PM
