Rtech Supercharged Bulldog 540 ... 850 HP!
#11
Originally Posted by tomcat
I picked up the dyno printout today. These are the observed HP numbers at a blower inlet temp of 90F.
Thats is a nice curve!!! Congrats. That will be a strong runner in that boat.
Rob
__________________
.
The Only Time You Have To Much Ammo Is When Your Swimming Or On Fire.
.
The Only Time You Have To Much Ammo Is When Your Swimming Or On Fire.
#12
Thread Starter
Registered
Joined: Feb 2001
Posts: 1,519
Likes: 32
Thanks Rob. We did not go above 5400 because of the stock valvetrain. The dyno boost gauge wasn't working properly but 7 psi is typical for this setup.
Did you get your new drives yet?
Did you get your new drives yet?
#13
Originally Posted by tomcat
Thanks Rob. We did not go above 5400 because of the stock valvetrain. The dyno boost gauge wasn't working properly but 7 psi is typical for this setup.
Did you get your new drives yet?
Did you get your new drives yet?
No
But Dean loaned me some to use ,Lucky there!!! I been fighting water leaks with them. I ran the hole TickFaw poker run with water in it
I tore it down last night it looks like it didn't hurt it .I believe in that Amsoil.I Resealed it ,I hope to be good for a while . I am hoping to get the new drives in a week or 2 .Maybe the new crescent lower will pick it up some with the new HP I have?I told Dean at the Bravo Shop today that at the Poker Run I turned it up to 11.5 lbs of boost on his loaner drives
He didn't think it was funny
Tom let us know how the boat runs. I would be curious as to what speed it picks it up.That's a lot of power in that boat.Should be fun
Rob
__________________
.
The Only Time You Have To Much Ammo Is When Your Swimming Or On Fire.
.
The Only Time You Have To Much Ammo Is When Your Swimming Or On Fire.





