I'm looking to put both of my motors on a dyno not only to check the HP/Tourque but also to get the motors all set up & dialed in. What type of cost should I expect to pay for these HP500's to be dynoed and are there any suggestions in the Greensboro NC or Roanoke VA area?

$500 for the day is usually the norm.

Jim,
nearest one around here is Sonny Leonard in lynchburg.

That is pretty reasonable. We see $ 600+ on average. Regardless it is the proper way to set up that large of an investment.

i pay five hundred a day when i do one i use Par in Spartanburg S.C. Also Keith Dorton up in Concord N.C. can do them, the last time i used him he was five hundred also

I just paid $700 in the Kansas City area.

sonny leonard

Would that be $500 a motor? Or $500 a day as long as I can get both motors in & on?

is that your 1470 horse motor? :

Engine dyno cost can vary depending on the amount of attention needed on a given engine. On a normally aspirated engine like yours we charge $650.00 to dyno the engine. If you are looking to remap then it can get time consuming.

Dean Gellner