Ok, not trying to start up something but did.nt this design have the vented steps that S. Koss designed?

I don't see them in the mold, maybe a lift out tooling section?

Interesting name Paragon?

Wannabe

Could order the boat with or without steps.

Are these the molds that made the one off that was for sale ?. The one Jason was looking at and ApacheCarl got the boot over. It was 60k ? Did someone buy it? If so just curious to hear how it turned out with all the R&D in it.

How long did you work there?

The T4 that was the One Off that you are referring to was NOT made from the mold, that mold has NEVER had any boat laid up in it. The T4 was one they did by hand out of the original mold and then worked on for MONTHS to get it right. Just to clarify that point. I had talked to the liquidiation company that was selling it and to verify a few points.
NO MSO came with the boat, No HID number nothing.
No parts came with the boat, you just got raw fiberglass parts, not even assembled, All the custom goodies we ordered and had made for the T4 are GONE,
No engines, the 1200 Cobra power engines are gone
No drives the #6 DS drives for the boat are GONE!
Dana marine products, K planes, hatch hinges, all the powder coated stuff, gauges and bezels, all the membrane switches all gone.
I dont know if they still have it or not, I got them down to 50 grand and I told them that without an MSO and the name "apache" on it, you are not going to get that dollar amount, they decided to hold out hope that they would, I said I would give them 25 grand right then and there and they denied me, so oh well.
J

2 months and then they laid just about everyone off.

Give Bobby the 36's back, back where they belong.

who has them?

these guys

Man that's alot of money sitting there going to waste. Too bad they couldn't get that deal off the ground.