need your advice tonight (saturday) on Drives
#11
Originally Posted by cuda
You don't think the linkage is hooked up wrong? Remember when we tested mine? It wouldn't move because the one we had the engine out on had the linkage wrong. You fixed it in about thirty seconds. 

#12
Originally Posted by offshoredrillin
never doubt a "perf family member" old man...


It was strange. I got it off the trailer, and put both drives in reverse, and the boat just kind of sat there. At first, I thought I must have been hard aground.
Timmy knew exactly what it was, just hooked the linkage on the other end of the lever.
#13
Thread Starter
Registered

Joined: Jun 2004
Posts: 8,230
Likes: 580
From: St-Hyacinthe, quebec, canada
switched the props and of course everything came ok...BUT! Have a little whistle when shifting forward, goes louder following RPM. Maybe Hot Pursuit was right... burned clutch ? Have to check this week...
Thanks for your advice!
Thanks for your advice!
Thread
Thread Starter
Forum
Replies
Last Post
bigo181979
General Boating Discussion
11
06-17-2008 07:51 AM
damdonzi
General Boating Discussion
15
11-10-2004 02:21 PM




