Top Gun engine mount project.
 

Stripping the paint from the engine mounts for my Top Gun exposed some corrosion between the main plate and the stiffining flanges. There was also some mild surface rust that needed to be removed.

Re: Top Gun engine mount project.
 

I decided that the only way to remove the rust completely was to cut off the flanges, clean up the edges of the plates, make new flanges and weld them on.
Here are a couple of pictures that I took of the process.

Re: Top Gun engine mount project.
 

After I removed the flanges. I cleaned up the plates and started bending and fitting new flanges.

Re: Top Gun engine mount project.
 

as always a class job.........from a class guy!!!!!!!!!!!!!!!.........m.m..........

Re: Top Gun engine mount project.
 

Using an old block as a fixture to prevent the plates from distorting during the welding process, I tack welded the new flanges in place.

Re: Top Gun engine mount project.
 

I finished the welding with a continuous bead around both sides using the ''TIG'' process, to prevent water from entering the joint and causing any future problems.

Re: Top Gun engine mount project.
 

The next step is to clean up the factory welded area around the mounting pads and then on to paint.

Roger

Re: Top Gun engine mount project.
 

Thanks Mark.

Re: Top Gun engine mount project.
 

Nice welds, beautiful job.
Denny

Re: Top Gun engine mount project.
 

Nice work Roger! Now you need something to put ON those! :D