I finally finished my winter project and I am going to mount it on my Boat tommorrow.I made a Tunnel tab out of 3/8 inch 6061. It is 38 wide and 26 long.The braces for the cylinders are made of 6061 1x2 Aluminum all fastened with SS counter hex head bolts.The cylinders are OMC cobra.I had to wet sand by Hand down to 1500 grit.

The hinge was made by cutting out 3 inch sections of 1 and 1/4 6061 Aluminim rod and drilling a 5/8 inch hole(actually 4 thousandths over) and inserting a 5/8 inch SS rod.The pins for the cylinders are also 5/8 inch SS

Nice work!!!!

Nice!

Fred,
I will be in touch for an indicator as soon as I figure out were to put it.I thought that I had everything worked out,I planned alot but totally forgot about the space for an indicator.

Nice looking piece of hardware, what's it going on?

30 Shadowcat with twin Promax 300

Mark,

That looks great buddy.

Where have you been hiding?

Dock

Nice job!

Very nice job you did on that tunnel tab, What kind of speeds do you get out of the Shadow with the Pro max's ??
What year Shadow?