Originally Posted by mrhorsepower1

Downtown, I am not afraid to run my engines like others. They put the engine on warm it up, make two pulls and say it's finished. All of our marine engines get a minimum of 2-3 hours of actual run time. Warm up, break in , and testing. Cylinder heads are re-torqued , valve lash run a few times ( when applicable) , compression and leak down test performed after testing, ect. The Bad Boys are ready to rock when they go in the vessel. Of all the pairs or triples we have built, none have been no futher apart than 8 horsepower.

Originally Posted by mrhorsepower1

The third engine is going in. I wish I was in NJ....looking forward to getting out of the shop and doing some boating up there with Nick. Oh.....and of course Dee!!

Originally Posted by Downtown42

just kiddin around, you have a first class shop, watched your boat tv clips and would be on my list if I needed your expertise.

Originally Posted by mrhorsepower1

The third engine is going in. I wish I was in NJ....looking forward to getting out of the shop and doing some boating up there with Nick. Oh.....and of course Dee!!

Originally Posted by Panther

I thought the 3rd engine was going in on Wednesday?

Just got back from my boat though....installed the sub and speakers..it's LOUD!

Originally Posted by sakoutis3

It was supposed to be but we got held up with gettin the generator running. It was easier for Tommy to get his fat azz in there without the engine in the way. Its all good now. Everything works. You can't rush perfection.

Originally Posted by hunster

You're starting to sound like Gellner with the perfection crap!!!!!



Glad to hear you're finally getting there!!!

Originally Posted by sakoutis3

I heard you and Frank were doing alittle work on the Apache this weekend. Sound good????????