Offshoreonly.com
Page 2 of 3
1
2
3
Show 40 post(s) from this thread on one page

Offshoreonly.com (https://www.offshoreonly.com/forums/)
-   General Boating Discussion (https://www.offshoreonly.com/forums/general-boating-discussion-51/)
-   -   I Call Bullchit....... (https://www.offshoreonly.com/forums/general-boating-discussion/154399-i-call-bullchit.html)

TEAMBAJA 03-25-2007 04:42 PM
Did I read that right? 60 original hours on the hull, and its a 1987?

pshannon 03-25-2007 05:15 PM
Originally Posted by jeff1000man (Post 2070344)
Have you cahnged impellors yet this year?
No not yet,do the impellers need to be done every year????I think they were done last january when the new motors were put in...

jeff1000man 03-25-2007 05:35 PM
Originally Posted by pshannon (Post 2070375)
No not yet,do the impellers need to be done every year????I think they were done last january when the new motors were put in...
First thing I check when engine temp starts to fluctuate. Also simplest fix next to a leaky hose.

lightspeed 03-25-2007 05:49 PM
I Worked On That Boat At MRD And Its A Nightmare To Work On ..The Owner Did Dump Alot Of $$$$In It ,,It Is A 272 Runs In The 80S,,, Condition Is Average

cuda 03-25-2007 06:17 PM
Originally Posted by pshannon (Post 2070340)
Hey Cuda, you definetley have that right,someone dropped some cash in it,did you notice the K-planes on the back,also I think it's a 272....I just splashed mine today,took her down the river into annapolis harbor:evilb: .Ran great the first time out,just noticed that the starbord engine heated up a little :( not to bad but got to around 180 degrees and stayed their.I thinking thermostat,I'm going to post up in the formula section...
Do you have sea strainers? If so, checked that they don't need emptied. My 302 had one engine running warm, and the strainer was almost full of real fine shells and sand. Cleaned it out, and no problems afterwards.

GLH 03-25-2007 06:43 PM
... picture of the 100 MPH run... the boat is a little hard to spot...


http://www.venezuelatuya.com/canaima...toangel800.jpg

pshannon 03-25-2007 06:47 PM
Originally Posted by cuda (Post 2070409)
Do you have sea strainers? If so, checked that they don't need emptied. My 302 had one engine running warm, and the strainer was almost full of real fine shells and sand. Cleaned it out, and no problems afterwards.
Where would I find them if I had them??? I just bought the boat last year,it's my first boat.

pshannon 03-25-2007 06:48 PM
Originally Posted by GLH (Post 2070421)
... picture of the 100 MPH run... the boat is a little hard to spot...
LMAO....

99fever27 03-25-2007 07:31 PM
[QUOTE=GLH;2070421]... picture of the 100 MPH run... the boat is a little hard to spot...QUOTE]

I cant see it..maybe the shutter speed on the camera wasnt fast enough...:evilb:

cuda 03-25-2007 10:23 PM
Originally Posted by pshannon (Post 2070425)
Where would I find them if I had them??? I just bought the boat last year,it's my first boat.
They wil be low in the bilge, follow the line back from the seawater pump. Not all Formula's came with them, I'm sure they were an option. My 302 had the Kaama option, which came with a lot more things than just surface drives. 280 trim tabs, full hydraulic steering to name a couple.

I thought I had a picture of them, but I can't find it.


All times are GMT -5. The time now is 10:36 PM.
Page 2 of 3
1
2
3
Show 40 post(s) from this thread on one page


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.