NanoXcel any Manufacturers using it for hulls??
10-20-2007 | 06:38 PM
#1
Thread Starter
Banned
Joined: Dec 2003
Posts: 1,647
Likes: 0
From: st. louis,mo.
NanoXcel any Manufacturers using it for hulls??
This product is so strong , lightweight, performance, appearance superior to standard hull layup it can cut 25-30% of the total weight of the hull. which can translate to up to 10% increase in speed with the same power. We are looking into it now.
10-20-2007 | 07:18 PM
#2
Registered
Joined: May 2004
Posts: 596
Likes: 1
From: Okanagan Falls BC. Canada
Buddy OO , you can e-mail this fellow I know .
He's pretty knowledgeable about composite stuff.He's been working on a design that's using infusion . This boat is huge and running on a single engine . Here's a link to his site .
http://www.nava.ca/
He's pretty knowledgeable about composite stuff.He's been working on a design that's using infusion . This boat is huge and running on a single engine . Here's a link to his site .
http://www.nava.ca/
10-21-2007 | 07:11 AM
#4
VIP Member
Joined: Dec 2001
Posts: 10,397
Likes: 402
From: Cape Coral, Florida
Define "We"
__________________
Happily retired and living in Heavens waiting room.
Happily retired and living in Heavens waiting room.
10-21-2007 | 08:38 AM
#7
VIP Member
Joined: Dec 2001
Posts: 10,397
Likes: 402
From: Cape Coral, Florida
10-21-2007 | 08:44 AM
#8
Thread Starter
Banned
Joined: Dec 2003
Posts: 1,647
Likes: 0
From: st. louis,mo.
I believe I have stated that I'm a partner in Awesome powerboats. The facility is here in St. Louis.If you would like a tour email me. here are a few pics of some of the buildings, weve got a little 18,000 sq. ft. 12,000 conditioned,4 catamaran molds, flat bottom aluminum fishing boat molds, f1 mold,full fiberglass , paint, rigging, engine facility.
Last edited by Buddy OO; 10-21-2007 at 09:04 AM. Reason: facility pics
10-21-2007 | 08:47 AM
#9
VIP Member
Joined: Dec 2001
Posts: 10,397
Likes: 402
From: Cape Coral, Florida
