Does Stellings still make TRS to Bravo boxes?
02-12-2008 | 06:07 PM
#2
Registered
Joined: Jan 2004
Posts: 3,255
Likes: 17
From: Bay Area, CA
Randy had about 10 sets left last time I was there, about 3 months ago. They needed additional machining so I'm not sure they'll sell them. I think the problem is they don't have a good DTP for them since Jack kept all that stuff in his head.
You could always use a Konrad box! We're a Konrad dealer so give me a call and I'll get you set up.
Fionn
You could always use a Konrad box! We're a Konrad dealer so give me a call and I'll get you set up.
Fionn
02-04-2009 | 09:12 AM
#6
Platinum Member
Joined: Dec 2002
Posts: 15,270
Likes: 21
From: Burlington, VT
02-04-2009 | 09:44 AM
#7
Banned
Joined: Oct 2006
Posts: 5,844
Likes: 0
From: Bradenton Florida
I actually think the IMCO box is big enuff to cover the TRS cutout ???? Not shure but it can't be much or hard to make it work safe.
Incase they would not have them anymore.
In the worst case u would need to fill in the boltholes , thats not to bad at all.
Incase they would not have them anymore.
In the worst case u would need to fill in the boltholes , thats not to bad at all.
02-04-2009 | 09:53 AM
#9
Banned
Joined: Oct 2006
Posts: 5,844
Likes: 0
From: Bradenton Florida
WHY is that,,,,i had them and never ever had a problem.
The only reason i did recoment the IMCO for this matter is because they are bigger at the transom then the bravo stellings.
The only reason i did recoment the IMCO for this matter is because they are bigger at the transom then the bravo stellings.
Last edited by DareDevil; 02-05-2009 at 08:21 AM.
