502 or 454 how to tell ?
05-08-2009 | 01:24 PM
#12
Thread Starter
Registered
Joined: Jan 2003
Posts: 104
Likes: 0
From: ohio
Thanks for all the input ! I ran the numbers and its a Gen IV 502. All my stuff is gen VI so I didnt get it. If any one is looking for this type let me know. It was a crate motor and has never been apart,I got it started and it ran fine. The boat is junk. It has trans too.
Thanks again
Bill
Thanks again
Bill
05-08-2009 | 01:28 PM
#13
SORE MEMBER
Joined: Apr 2004
Posts: 6,984
Likes: 2
From: 29°50'49.74"N 95° 5'17.55"W.......TEXAS
Thanks for all the input ! I ran the numbers and its a Gen IV 502. All my stuff is gen VI so I didnt get it. If any one is looking for this type let me know. It was a crate motor and has never been apart,I got it started and it ran fine. The boat is junk. It has trans too.
Thanks again
Bill
Thanks again
Bill
You can run all your gen 6 accessories. Just install a fuel pump block off plate. The gen 6 engine does have some improvements to the castings affecting oiling and cylinder cooling I believe.
05-08-2009 | 02:02 PM
#14
Thread Starter
Registered
Joined: Jan 2003
Posts: 104
Likes: 0
From: ohio
Ill look into this a little more.I just hate to pass up a good deal on a big block. I think you talked me into it !! Yep Thanks
