|
header looks tarnished? Sounds good:drink:
|
Originally Posted by Strip Poker 388
(Post 2993351)
header looks tarnished? Sounds good:drink:
The header got tarnished the first week I had the boat because of some cooling issues. Chris |
Stage II should get it to 740HP...
|
Originally Posted by CB-BLR
(Post 2993179)
The water re-route was to pull water off the main line right after the raw water pump, instead of off the power steering cooler in order to get cooler water to the innercooler, and thus make more and safer horsepower.
Chris I have 29ft velocity with a 600 sci iam getting 80-82 on gps all stock.(same speed as yours before your mods.) Questions My oversized sea strainer has to outlets with one being plug right now, can i use the second outlet and run it to the innercooler versus adding another sea strainer / water pickup etc . Also to get to 700 hp all i have to do is have dustin reprogram ecu plug back in and go with seperate water line to innercooler . no pulleys/cam or anything . Thanks John |
Originally Posted by wellcrafted
(Post 2993429)
Chris
I have 29ft velocity with a 600 sci iam getting 80-82 on gps all stock.(same speed as yours before your mods.) Questions My oversized sea strainer has to outlets with one being plug right now, can i use the second outlet and run it to the innercooler versus adding another sea strainer / water pickup etc . Also to get to 700 hp all i have to do is have dustin reprogram ecu plug back in and go with seperate water line to innercooler . no pulleys/cam or anything . Thanks John You would have to pick the water up somewhere behind the sea pump. If you get it at the strainer there will be no pressure to force the water throught the intercooler. Not sure about the pulley. |
Originally Posted by CB-BLR
(Post 2993303)
Here is a video of the 700hp pass on the Whipple dyno:
http://www.youtube.com/watch?v=6BTsMEudtCw Chris So it made 700 with the reprogram and waterline upgrade? |
Correct... the motor made 700hp with only the PCM re-program & water re-route. No other mods of any kind.
You do not want to pull the water off the sea-strainer... Dustin has the correct parts in his kits to re-route the innercooler water... very easy mods. Chris |
The new numbers are in for the Stage II upgrade for the 600sci:
752hp at 5850rpm ! This is what you get with just a PCM re-program, a water re-route, and a smaller pulley. Dustin rocks! |
Originally Posted by CB-BLR
(Post 2993663)
The new numbers are in for the Stage II upgrade for the 600sci:
752hp at 5850rpm ! This is what you get with just a PCM re-program, a water re-route, and a smaller pulley. Dustin rocks! |
I will be running stage IV+ :evilb:
I explained the stages in my first post. Chris |
| All times are GMT -5. The time now is 03:06 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.