|
Originally Posted by Rik
(Post 3103550)
Brad Smith
417-499-7855 |
Originally Posted by Rik
(Post 3088753)
You know that if you had put Arnesons on it you would not have to so concerned about breaking a #6! :D
|
Originally Posted by FasterFaster
(Post 3103660)
But he probably wants it to go where he points it...:party-smiley-004:
|
sorry, been busy fixing other engine builders mistakes... we have started working on these again.. i will post some dyno videos in a day or two...
|
not bad for our 5 psi pump gas setting... lots of cubic inches and no blower drag equals lots of power
http://www.youtube.com/watch?v=cDJ0sdHid04 |
what correction factor was used?
|
Originally Posted by villecountryclub
(Post 3106506)
what correction factor was used?
probably a couple hundred more hp then your engine builder made for your boat and we don't have to use a fake correction factor... |
Lets see a full pull.........................:)
Squeeze em |
Originally Posted by Bigyellowcat
(Post 3106487)
not bad for our 5 psi pump gas setting... lots of cubic inches and no blower drag equals lots of power
http://www.youtube.com/watch?v=cDJ0sdHid04 |
Originally Posted by Bigyellowcat
(Post 3106487)
not bad for our 5 psi pump gas setting... lots of cubic inches and no blower drag equals lots of power
http://www.youtube.com/watch?v=cDJ0sdHid04 Looks like you'll get a little more than your estimate at 1/2 atmosphere. Sweet! |
| All times are GMT -5. The time now is 11:38 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.